The Breitling Watch Source Forums

Hi, I'm new here.

I've been collecting "vintage" watches only for 2 years so far, so quite a baby there. Since (my) beginning I've been interested in a Chrono matic 2110.

Here is one I found on the net. I just have doubts that the dial is correct for this model. The owner is honest and was told it was all original but browsing on internet for hours and reading articles I can not find any similar subdial (I'm referring to the small dots close to the figures on the left side, and on the orange painting a little bit off in the right one).
Can someone confirm if this is a redial/unconsistent refurbished one, or instead a proper coherent one ?

Here is the picture (following the forum rules and using imgbb, hope I do this right) :

https://ibb.co/qnm96LG (2nd attempt)

Thanks for sharing your knowledge and enabling guy like me to humbly join you

your photo link doesn't work for me.

Thanks for letting me know. I've done it again and changed it in my initial post !

I believe that dial is reprinted. There are other oddities about it too, including the size of the subdial numbers on the right, the “UHP” should be red....

The print quality looks pretty good though - “Geneve” looks a bit blobby, but that might be the Crystal. Maybe a Service replacement dial?

Thanks @buddman
I think so too... maybe I'm too gritty but I will let it go then as I would like to have a watch fully original (or at least as far as I can say). Thanks a lot for your help. I appreciate.