The Breitling Watch Source Forums

Hi folks,

I have a Breitling Chrono Avenger that came with an additional band, specifically a rubber strap. The strap had a Panerai style buckle, but I'd like to change the buckle back to a Breitling buckle.

When I look at the buckle, the pin that affixes the buckle to the end of the rubber strap doesn't seem show the part where I can push in to release the buckle from the strap. Is there a trick to changing the buckles on Breitling rubber straps (Pro 1)? I'm sure the pin is similar to a "spring bar".

Thanks,

Vernon

It is a spring bar. You need to remove it the same as you would removing a leather strap from the watch.


Sent from my iPhone using Tapatalk

_________________
SHARKMAN

Thanks, I will look at it again. When I quickly checked last night, I didn't see a way for me to push on the spring pins as the rubber was right at the edge of the inside of the buckle.

I did it, thanks for the tips.