The Breitling Watch Source Forums https://www.breitlingsource.com/phpBB2/ |
|
Wakmann Triple Date Questions https://www.breitlingsource.com/phpBB2/viewtopic.php?f=6&t=65491 |
Page 1 of 1 |
Author: | demalick007 [ Fri Mar 08, 2019 6:51 pm ] |
Post subject: | Wakmann Triple Date Questions |
I am looking at a Wakmann Triple Date (from 1967). Questions... Did some of them came with hands from Gigandet Triple Dates? It also has the Valjoux 72c with WOG bridge movement instead of the Valjoux 730. Does this sound correct? Hopefully, this is posted in the correct place. I appreciate any help. Thank you Sent from my SM-G950U using Tapatalk |
Author: | WatchFred [ Sat Mar 09, 2019 2:02 am ] |
Post subject: | Re: Wakmann Triple Date Questions |
these are typically discussed in the vintage segment, but fine here too. a picture would help, but the „Wakmann“ or „Vulcain“ tripledates were all made by Gigandet, sometimes co-branded. earlier examples were 72c, then 730 - so to say if a particular hands design combination is correct, we‘d have to see the dial, please |
Author: | demalick007 [ Sat Mar 09, 2019 7:21 am ] |
Post subject: | Re: Wakmann Triple Date Questions |
Thank you WatchFred. Here are the pictures: Thanks WatchFred wrote: these are typically discussed in the vintage segment, but fine here too.
a picture would help, but the „Wakmann“ or „Vulcain“ tripledates were all made by Gigandet, sometimes co-branded. earlier examples were 72c, then 730 - so to say if a particular hands design combination is correct, we‘d have to see the dial, please |
Author: | WatchFred [ Sat Mar 09, 2019 9:05 am ] |
Post subject: | Re: Wakmann Triple Date Questions |
would expect this dial execution & hands on a later cal. 730 piece, but not enough documentation to be sure |
Author: | demalick007 [ Sat Mar 09, 2019 9:39 am ] |
Post subject: | Re: Wakmann Triple Date Questions |
Thank you. I greatly appreciate your help. I will probably pass on this one. Thanks again. Dale WatchFred wrote: would expect this dial execution & hands on a later cal. 730 piece, but not enough documentation to be sure
|
Page 1 of 1 | All times are UTC - 8 hours |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |