| The Breitling Watch Source Forums https://www.breitlingsource.com/phpBB2/ |
|
| Hello From Minnesota https://www.breitlingsource.com/phpBB2/viewtopic.php?f=4&t=410 |
Page 1 of 1 |
| Author: | gnielse [ Fri Aug 17, 2007 10:31 pm ] |
| Post subject: | Hello From Minnesota |
Hello All, I’ve just purchased my first nice watch, and I’m a little nervous. I found a used Duograph, World Cup of Aerobatics edition on the internet. It needs some work. The 12 hour hand is off by 25 or 30 minutes from the minute hand. The 24 hour hand is fine. Do you have any suggestions on where to have repairs made? I’ve read a few comments that Breitling can be very slow, as in months, and pretty expensive. Do any of you have a ballpark what that service would run? I’m assuming the Duograph has a pretty unique movement, so it will probably be more than other Breitlings. I would also like to have a link added to the bracelet. I assume an AD is the only way to go for that. The man I bought it from was very nice, and included the original receipt, the receipt for the Pilot band he picked up later, and the warrantee info, including one service record from 1998. The receipts are from the same dealer as the warrantee card, so things look in order to me, but I’m not an expert. I wish I would have found this forum before I bought it. There is some great information on authentication. I’ll be calling BUSA on Monday. Thanks in advance for any advice. |
|
| Author: | breitlingsource [ Sat Aug 18, 2007 8:33 am ] |
| Post subject: | |
Welcome to the forum Grant! The Duograph is a nice little gents watch, the watch's movement is based on the ETA 2892 movement so that shouldn't be hard for anyone to work on. It will be more money than a typical 2824 movement, but it probably wont' cost as much as servicing a Chronograph. If your minute had is 25-30 minutes off, but the watch is keeping perfect time you could ask someone to just move the minute hand to the correct spot... but chances are if it hasn't been serviced ever, the watch will need a full overhaul and some parts will need replacing. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|