The Breitling Watch Source Forums
https://www.breitlingsource.com/phpBB2/

Chronomat 44 Bracelet Screwdriver Size
https://www.breitlingsource.com/phpBB2/viewtopic.php?f=29&t=63186
Page 1 of 1

Author:  *dan* [ Tue Jul 18, 2017 6:45 am ]
Post subject:  Chronomat 44 Bracelet Screwdriver Size

Hi everyone,

I'm trying to find a small flat head screwdriver attachement (ideally to go on my burgeon tool) that allows me to tighten the small screws that connect the security clasp to the bracelet. They came off a while ago and don't want to have to send it back for that - be easier if I could just tighten them myself.

I have some picture attached below...

Thanks

Author:  Roffensian [ Tue Jul 18, 2017 10:27 am ]
Post subject:  Re: Chronomat 44 Bracelet Screwdriver Size

1.6mm

Author:  *dan* [ Sat Jul 22, 2017 1:40 am ]
Post subject:  Re: Chronomat 44 Bracelet Screwdriver Size

Roffensian wrote:
1.6mm


Thanks for that ... Is it definatly 1.6mm for the smaller screws that are on the clasp as these screws seem slightly smaller than the ones on the side of the bracelet itself. Don't want to order the wrong one!

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/