The Breitling Watch Source Forums
https://www.breitlingsource.com/phpBB2/

question on Navitimer's deployant
https://www.breitlingsource.com/phpBB2/viewtopic.php?f=29&t=45182		 Page 1 of 1
Author:  rik [ Tue Jan 22, 2013 3:06 am ]
Post subject:  question on Navitimer's deployant
examining forumers pictures of their deployant it seem to me that there is no retention of the strap at the buckle side. Am I wrong? Is there the risk that, if the buckle is open and the watch hangs, the strap lift away and the watch fall?
Author:  Roffensian [ Tue Jan 22, 2013 5:12 am ]
Post subject:  Re: question on Navitimer's deployant
It's friction fit and it's not going to fall out.
Author:  breanach78 [ Tue Jan 22, 2013 5:21 am ]
Post subject:  Re: question on Navitimer's deployant
rik wrote:
examining forumers pictures of their deployant it seem to me that there is no retention of the strap at the buckle side. Am I wrong? Is there the risk that, if the buckle is open and the watch hangs, the strap lift away and the watch fall?

It will not fall out but I have had slight slippage on all of my DPLs.
On mine I have squeezed the two lugs down onto the strap VERY carefully so that it gives extra pressure on the adjustable side of the strap.
I have found that it holds its size better and does not allow the slippage.
Might not be that relevant to OP but may help a little.

:lingsrock:
Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/