| The Breitling Watch Source Forums https://www.breitlingsource.com/phpBB2/ |
|
| after winding, still doesn't run https://www.breitlingsource.com/phpBB2/viewtopic.php?f=12&t=9769 |
Page 1 of 1 |
| Author: | ross1 [ Fri Apr 24, 2009 10:26 am ] |
| Post subject: | after winding, still doesn't run |
I am trying to figure out why my Colt GMT doesn't run? I gave it a full wind, haven't hit it on anything or dropped it but it doesn't run at all? Does anyone know what may cause this? I have an extended warranty through tornuea but their customer service was a little cold and lacking on the phone and I'm reluctant to send it to them... can anyone tell me what the cause could be? Thank you in advance, Ross |
|
| Author: | Roffensian [ Fri Apr 24, 2009 10:30 am ] |
| Post subject: | Re: after winding, still doesn't run |
If winding it doesn't cause it to run at all then there are many possible causes - obvious ones - a broken winding mechanism or a broken mainspring. Give it a good 'shake' to get the rotor going well and if it runs after that then it may be the winding mechanism, if not, likely the mainspring. Either way it's a warranty issue. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|