| The Breitling Watch Source Forums https://www.breitlingsource.com/phpBB2/ |
|
| Screwing in the crown. https://www.breitlingsource.com/phpBB2/viewtopic.php?f=12&t=7797 |
Page 1 of 1 |
| Author: | cRaSiAn1030 [ Tue Feb 10, 2009 6:42 pm ] |
| Post subject: | Screwing in the crown. |
For watches that have a crown that you can screw in and out to adjust the time/date/etc. Is it possible to screw it back in too hard and break it? Like after you're done adjusting everything. Thanks, cRaSiAn1030 |
|
| Author: | aleister [ Tue Feb 10, 2009 11:56 pm ] |
| Post subject: | Re: Screwing in the crown. |
In theory yes, but if you're using common sense and stop when it feels reasonably tight you're fine. |
|
| Author: | Driver8 [ Wed Feb 11, 2009 3:20 am ] |
| Post subject: | Re: Screwing in the crown. |
Aleister is correct. You certainly don't need to massively over-tighten the crown as it's the gaskets (and not a metal on metal seal) that provides the water resistance. Finger tight is fine. |
|
| Author: | cRaSiAn1030 [ Wed Feb 11, 2009 2:42 pm ] |
| Post subject: | Re: Screwing in the crown. |
ok thanks. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|