| The Breitling Watch Source Forums https://www.breitlingsource.com/phpBB2/ |
|
| Chrono Avenger M1 question https://www.breitlingsource.com/phpBB2/viewtopic.php?f=12&t=53253 |
Page 1 of 1 |
| Author: | No Quarter [ Sun Apr 06, 2014 11:42 pm ] |
| Post subject: | Chrono Avenger M1 question |
Hi After fiddling a bit with the stop watch, the white/red seconds arm doesn't move anymore, it's stuck in 1 second position, should be stationary in vertical position. Does anyone know how to move it, I can set everything else? Wonder why it just stopped, just had a new battery put in, so may have go back to dealer, but that's far away from me... Any help will be appreciated |
|
| Author: | Roffensian [ Mon Apr 07, 2014 1:45 am ] |
| Post subject: | Re: Chrono Avenger M1 question |
If it's not moving at all then it's likely a servicing issue. If the chrono seconds hand isn't moving then I assume that none of the chronograph hands are moving? It's possible that something happened during the battery change or it could just be that the watch is due for a service. Welcome to BreitlingSource. |
|
| Author: | No Quarter [ Mon Apr 07, 2014 1:51 am ] |
| Post subject: | Re: Chrono Avenger M1 question |
All the other hands move, so probably a service issue... |
|
| Author: | Roffensian [ Mon Apr 07, 2014 2:00 am ] |
| Post subject: | Re: Chrono Avenger M1 question |
No Quarter wrote: All the other hands move, so probably a service issue... So chrono seconds hand doesn't move but chrono minutes does???? That makes little logical sense, the only way that could happen that I can think of is if the seconds hand were slipping on the arbor (i.e. the arbor is turning but the hand isn't) and that would likely cause the second hand to slide around because it was loose. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|