The Breitling Watch Source Forums
https://www.breitlingsource.com/phpBB2/

Need help?? Crown and stem size on a Breitling Chronomat GT
https://www.breitlingsource.com/phpBB2/viewtopic.php?f=12&t=42147		 Page 1 of 1
Author:  dgehrels [ Fri Aug 24, 2012 2:36 pm ]
Post subject:  Need help?? Crown and stem size on a Breitling Chronomat GT
Hey guys,

What is the right stem and crown size for a Breitling Chronomat GT B13050.1?

The diameter I believe is 5.25MM but what is the stemsize, 0.90 or 1.2 MM?

I am replacing the one on mine because of the faded gold.

Thanks,
Author:  Driver8 [ Fri Aug 24, 2012 3:42 pm ]
Post subject:  Re: Need help?? Crown and stem size on a Breitling Chronomat
Sorry I can't help you with the sizes, but you will struggle to get hold of a Breitling crown anyway as Brfeitling won't sell you the parts. You'll probably be better off just getting Breitling to replace the crown for you.
Author:  dgehrels [ Sat Aug 25, 2012 3:32 am ]
Post subject:  Re: Need help?? Crown and stem size on a Breitling Chronomat
I found some original crown on ebay but am not sure as to the stemsize. Anybody who know?
Author:  dgehrels [ Sat Aug 25, 2012 8:57 am ]
Post subject:  Re: Need help?? Crown and stem size on a Breitling Chronomat
Nobody knows?
Author:  Roffensian [ Sat Aug 25, 2012 9:19 am ]
Post subject:  Re: Need help?? Crown and stem size on a Breitling Chronomat
dgehrels wrote:
Nobody knows?


It's not somehting that very many people would care about. Knowing that Breitling don't sell parts they would just have Breitling replace the crown and stem.
Author:  coltstrong [ Thu Jan 03, 2013 11:15 pm ]
Post subject:  Re: Need help?? Crown and stem size on a Breitling Chronomat
Anyone have an idea of pricing for Breitling to replace crown and pushers? Also if they did would they upgrade to capped gold design vs old plating style?
Author:  Roffensian [ Fri Jan 04, 2013 5:07 am ]
Post subject:  Re: Need help?? Crown and stem size on a Breitling Chronomat
coltstrong wrote:
Anyone have an idea of pricing for Breitling to replace crown and pushers? Also if they did would they upgrade to capped gold design vs old plating style?


Parts aren't expensive, although gold increases the cost, but get it done as part of a regular service to save on labour because that can push the cost in to the hundreds of dollars range easily. If you are replacing gold plated parts then I believe that they now automatically use the rolled gold pieces.
Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/