The Breitling Watch Source Forums
https://www.breitlingsource.com/phpBB2/

Cosmonaute snapped crown
https://www.breitlingsource.com/phpBB2/viewtopic.php?f=12&t=18699
Page 1 of 1

Author:  Cosmo [ Thu Apr 22, 2010 11:03 am ]
Post subject:  Cosmonaute snapped crown

Hi All,

Newbie here. I just received my watch back from a $200+ service, which is bs. I think it is a total design flaw, that the crown does not screw down. Everytime I reach deep in my pockets, etc and pull out, the crown head gets caught and forcefully pulled out. This caused the first snapping of the shaft within the case and bound to happen again. Anybody else have these issues and know of a remedy for them? Maybe an accessory to keep the crown in place or a mod, etc?

Author:  Roffensian [ Thu Apr 22, 2010 11:13 am ]
Post subject:  Re: Cosmonaute snapped crown

Can't say that I have ever had that problem. I've caught a pusher a couple of times, but never the crown. Sorry, there is nothing that I can think of that would prevent it.

Author:  Cosmo [ Mon Apr 26, 2010 5:48 am ]
Post subject:  Re: Cosmonaute snapped crown

Roffensian wrote:
Can't say that I have ever had that problem. I've caught a pusher a couple of times, but never the crown. Sorry, there is nothing that I can think of that would prevent it.

ok, thanks

Author:  daimlerblue [ Fri Apr 30, 2010 10:50 pm ]
Post subject:  Re: Cosmonaute snapped crown

If you wear your Ling on your left hand .........sew up the pocket on that side of your pants.
This will stop you using your watch hand for whatever reason you mess about with deep pockets for.... :roll: ...........problem solved ! :lol:

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/