The Breitling Watch Source Forums

hi there,

great site i have browsed lots of times before but have only just registered.
i have two breitlings, a superocean professional and an avenger seawolf(titanium).

i have a problem with the bracelet on my superocean, the clasp spring bar that holds the expander side of the bracelet to the clasp has broken and i need to find a replacement.the bracelet size is i think 18mm at the clasp so do i need 18mm or 17 mm spring bars.and also what type telescopic,single shoulder,double shoulder,double or single flange.
the choice seems endless
hope you can help
gary

Welcome to BreitlingSource!

The SuperOcean is 20mm at the lugs (unless we are talking a vintage superocean) so you need 20mm springbars. In terms of what type - to be honest I just ask my AD for a handful, not sure exactly what type they are

you're right it is 18mm at the clasp, are you talking about the spring pin that conects the drivers extension to the clasp? If so you would be fine with a 18mm spring bar pin.

_________________

TREVOR

If you are near an AD, just take it there.

If not, I would assume you need one which matches the one at the other side of the clasp.

_________________

For more information on identifying Breitling replicas, please visit my web site
http://f4buz.com/watches/breitling/fakes/fakes.html

thanks for the replies

the bars are the ones at the clasp extension
i have found a few web sites where i can get them from

thanks again

Oh - sorry - I didn't realise that it was the clasp end.

My bad!