The Breitling Watch Source Forums
https://www.breitlingsource.com/phpBB2/

Help with Top Time 2000 crown - what size?
https://www.breitlingsource.com/phpBB2/viewtopic.php?f=11&t=60559		 Page 1 of 1
Author:  levkov [ Wed May 25, 2016 11:07 pm ]
Post subject:  Help with Top Time 2000 crown - what size?
Hi All,
I need help with my Top Time 2000 (gold plated / black dial & silver subdials) project that I've been working on for about 6 months.
The only part missing now is the crown.
Does anyone know what size i should be looking for (diameter / width / tap size)?
I measured my wifey's Top Time 2003 crown (posted here few months back), that's around 5.86mm diam / ~3mm wide, but I'm not sure if the 2000 would be the same size, and (without disassembling) I couldn't measure the tap size, either.
If someone happens to have one lying around, that'd be even better :) - PM me with an offer.
Thanks in advance folks,
Bless you all
Author:  WatchFred [ Thu May 26, 2016 12:07 am ]
Post subject:  Re: Help with Top Time 2000 crown - what size?
size is correct, bit below 6mm.
not easy to find in GP
Author:  WatchFred [ Thu May 26, 2016 1:47 am ]
Post subject:  Re: Help with Top Time 2000 crown - what size?
sorry, overlooked the stem question, tap 6 1.2mm
Author:  levkov [ Thu May 26, 2016 9:51 am ]
Post subject:  Re: Help with Top Time 2000 crown - what size?
Thanks a lot Fred;

Do you think this would fit (even though it's slightly larger in diameter)?:
http://www.ebay.co.uk/itm/231857184419? ... EBIDX%3AIT

Or, would it be a bad idea to plate a ss one? :wink:

Thanks,
Lev
Author:  WatchFred [ Thu May 26, 2016 2:25 pm ]
Post subject:  Re: Help with Top Time 2000 crown - what size?
nope, would not look right on a 2000

if done properly, plating an ss will work.
Author:  levkov [ Thu May 26, 2016 11:11 pm ]
Post subject:  Re: Help with Top Time 2000 crown - what size?
Awesome, thanks a lot Fred... again! :bow:
Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/