| The Breitling Watch Source Forums https://www.breitlingsource.com/phpBB2/ |
|
| Pult 7101 and 2117 parts interchangeability https://www.breitlingsource.com/phpBB2/viewtopic.php?f=11&t=56486 |
Page 1 of 1 |
| Author: | tcsasser [ Thu Jan 01, 2015 7:46 pm ] |
| Post subject: | Pult 7101 and 2117 parts interchangeability |
Hello and thanks for looking. I recently purchased a reference 2117 Pult and am considering changing the bezel. There are a couple of ref. 7101 cases available with excellent bezels but I do not know whether the bezel is interchangeable between these references. Any assistance with this question is greatly appreciated. Thanks, TCS |
|
| Author: | saabreit [ Thu Jan 01, 2015 11:57 pm ] |
| Post subject: | Re: Pult 7101 and 2117 parts interchangeability |
Pushers, bezel, crystal and under crystal ring are common to 7101 and 2117. |
|
| Author: | tcsasser [ Fri Jan 02, 2015 5:46 am ] |
| Post subject: | Re: Pult 7101 and 2117 parts interchangeability |
Excellent - thank you! Happy New Year. |
|
| Author: | chronodeco [ Mon Jan 05, 2015 6:21 pm ] |
| Post subject: | Re: Pult 7101 and 2117 parts interchangeability |
Note - the crystal holds the bezel on. DO NOT attempt to pry the crystal off from the outside. Use a sharp case opener end and a small hammer inside the case in multiple locations to remove the crystal. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|