| The Breitling Watch Source Forums https://www.breitlingsource.com/phpBB2/ |
|
| Top Time crown dimensions https://www.breitlingsource.com/phpBB2/viewtopic.php?f=11&t=45254 |
Page 1 of 1 |
| Author: | GA1911 [ Fri Jan 25, 2013 4:42 am ] |
| Post subject: | Top Time crown dimensions |
I am looking for the dimensions of a Top Time 810 crown. I need a replacement signed crown and want to keep the watch as authentic as possible. I'll need the diameter (I think 6mm), tap, and tube. Thanks for your help... |
|
| Author: | WatchFred [ Fri Jan 25, 2013 5:19 am ] |
| Post subject: | Re: Top Time crown dimensions |
here's a crown thread w/ Craig/chronodeco comments. viewtopic.php?f=11&t=45062 TT810 crowns are 6mm indeed. |
|
| Author: | GA1911 [ Fri Jan 25, 2013 10:56 am ] |
| Post subject: | Re: Top Time crown dimensions |
I have been calling around looking for a crown, and on one call with a repair shop (one that I found listed on this forum) I was told that some Top Time 810 models did not have a signed crown, rather a plain one. Anyone heard or seen this before? I have looked at many images online and never seen one without a signed crown. |
|
| Author: | WatchFred [ Fri Jan 25, 2013 11:28 am ] |
| Post subject: | Re: Top Time crown dimensions |
ex works all had a signed crown, but these were quite often replaced w/ neutral crowns during service. |
|
| Author: | GA1911 [ Fri Feb 08, 2013 1:12 pm ] |
| Post subject: | Re: Top Time crown dimensions |
Heard from Craig on the dimensions for the signed crown, so thought I would post here in case anyone needed them. WatchFred confirmed it is 6mm diameter, and Craig said it is a tap 6 and tube 2.6 but a 2.5 will work. The only thing I didn't ask about was the width, but I found one on eBay that is 2.75mm and I think that will be close. Hope this helps someone in the future. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|