3mm Forked end for the S 1mm fork end for the F.
I have the F as well
| The Breitling Watch Source Forums https://www.breitlingsource.com/phpBB2/ |
|
| Bracelet tool https://www.breitlingsource.com/phpBB2/viewtopic.php?f=1&t=6996 |
Page 1 of 1 |
| Author: | steelfish [ Sun Jan 11, 2009 1:40 pm ] |
| Post subject: | Bracelet tool |
Can anyone tell me the type/brand name of the tool used in the video (in the FAQ section)to change a Breitling bracelet? Where would I go to buy one? Price? Thanks |
|
| Author: | Roffensian [ Sun Jan 11, 2009 1:55 pm ] |
| Post subject: | Re: Bracelet tool |
I'm at home in the land of no high speed internet, so can't see the video, but from memory it's a Bergeon 6767F - if it's a single bar tool as opposed to the one that compresses both ends of the spring bar at the same time, that's what it will be. I get my tools from www.watchtool.co.uk |
|
| Author: | steelfish [ Sun Jan 11, 2009 2:29 pm ] |
| Post subject: | Re: Bracelet tool |
Thanks. I noticed the website has two single bar models. One is the 6767-F the other is 6767-S. Is there a difference or will either one work? What does the letter indicate? |
|
| Author: | In2Deep [ Sun Jan 11, 2009 2:36 pm ] |
| Post subject: | Re: Bracelet tool |
3mm Forked end for the S 1mm fork end for the F. I have the F as well
|
|
| Author: | steelfish [ Sun Jan 11, 2009 2:53 pm ] |
| Post subject: | Re: Bracelet tool |
Great. Thanks. F it is. |
|
| Author: | aleister [ Mon Jan 12, 2009 4:48 am ] |
| Post subject: | Re: Bracelet tool |
That tool is great to have. I tried other models before (also Bergeon) but in some cases you really need that small fork to get the job done. If the tool's fork is too big, you'll just end up scratching the watch. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|