The Breitling Watch Source Forums
https://www.breitlingsource.com/phpBB2/

Seawolf 2 issues
https://www.breitlingsource.com/phpBB2/viewtopic.php?f=1&t=66016		 Page 1 of 1
Author:  Mircea [ Sun Jul 21, 2019 9:49 am ]
Post subject:  Seawolf 2 issues
I recently purchased a Breitling Avenger 2 Seawolf and I love it, but already have some problems with:

1. The bezel move both directions (because of me, I accidentally pressed the bezel to my desk) :cry:
2. My watch lose about a 10 seconds / day..The clock is manufactured in 2016, I bought it from November 2017 and it was in its box until last week when I started to use it. I've wind it properly, but it's still losing the 10 seconds ...
:?: Based to your experience, do you think I still have to worn it for about 3 weeks, in order to "settle in" or send it to AD to regulate..

Many thanks
Author:  Hunterfate [ Sun Jul 21, 2019 11:07 pm ]
Post subject:  Re: Seawolf 2 issues
It shows that that if you wear the watch it becomes more accurate if it was in the box for long. Keep on wearing it for a few weeks and it should go even below that 10sec/day.
Author:  Mircea [ Mon Jul 22, 2019 9:05 am ]
Post subject:  Re: Seawolf 2 issues
Thanks for answer mate. Ill try to be patient :(
Author:  usfelli2015 [ Mon Jul 22, 2019 3:28 pm ]
Post subject:  Re: Seawolf 2 issues
Bezel has a click Spring. Sounds as though you’ve either broken the little tab on it , or bent it back. I would think you’d be able to get that fixed without sending to Breitling. An AD may be able to source that for you. I bought a new complete bezel & springs set up for my SO Chrono II on eBay a couple years back.
I’ve re-bent the tab before on a couple of my watches when the tab wears from use, to make the action more positive. Good luck.
Author:  DreamWatcher [ Wed Aug 07, 2019 12:57 pm ]
Post subject:  Re: Seawolf 2 issues
Hunterfate wrote:
It shows that that if you wear the watch it becomes more accurate if it was in the box for long. Keep on wearing it for a few weeks and it should go even below that 10sec/day.

Try and put her on a watch winder when not wearing her... keeps the mechanism running, avoids oils getting stuck where they shouldn't, etc.
Always helps!
Cheers,
PG
Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/