The Breitling Watch Source Forums
https://www.breitlingsource.com/phpBB2/

Super Avenger Blacksteel Rubber OEM strap
https://www.breitlingsource.com/phpBB2/viewtopic.php?f=1&t=65306
Page 1 of 1

Author:  Alol [ Thu Jan 24, 2019 6:09 am ]
Post subject:  Super Avenger Blacksteel Rubber OEM strap

Hi,
I have recently acquired an SA BS. The keeper is missing off the OEM (122S) strap. No biggie but I am going to buy off of those ebay cheapies as Breitling God bless them will not supply just the keeper. So the watch being an SA is a 24-20. What internal diameter should I get a 22mm or 24mm. My thinking is 22, Just wondered if anyone had done the same before on here.

Thanks

Author:  Damnfoolman [ Fri Jan 25, 2019 12:29 am ]
Post subject:  Re: Super Avenger Blacksteel Rubber OEM strap

Hi,

You need to get the 24mm strap to match the lug width. It’s surprising how much play you get dropping 2mm. Below is a link to a picture of my Navitimer World with the 24mm Camel Croc strap. You can see it fits perfectly with no gaps. It’s the same for the rubber straps too

Hope that helps.

Davey.

https://flic.kr/p/Fwjewu

Author:  usfelli2015 [ Fri Jan 25, 2019 5:45 am ]
Post subject:  Re: Super Avenger Blacksteel Rubber OEM strap

Doesn’t the OEM strap taper to 20mm ?

Author:  Damnfoolman [ Sat Jan 26, 2019 2:00 am ]
Post subject:  Re: Super Avenger Blacksteel Rubber OEM strap

usfelli2015 wrote:
Doesn’t the OEM strap taper to 20mm ?


Hi,

Yes it does, 24-20 same on the OEM Rubber Diver.

D

Author:  Driver8 [ Sat Jan 26, 2019 3:51 am ]
Post subject:  Re: Super Avenger Blacksteel Rubber OEM strap

Damnfoolman wrote:
Hi,

You need to get the 24mm strap to match the lug width. It’s surprising how much play you get dropping 2mm. Below is a link to a picture of my Navitimer World with the 24mm Camel Croc strap. You can see it fits perfectly with no gaps. It’s the same for the rubber straps too

Hope that helps.

Davey.

I think the OP is just after a new keeper Davey, not a whole new strap.

That being the case, then I'd suggest getting a keeper with an internal size of 22mm would probably be fine as (as rightly noted) the strap itself tapers from 24mm to 20mm, so a 22mm keeper should do the job.... but that's assuming the keeper opening is essentially rectangular and the 22mm is the width of the "base" of the opening, if that makes sense. i.e. you will need to make sure the opening is big enough to accept the strap itself and then the tail as well.

Author:  Damnfoolman [ Sat Jan 26, 2019 1:44 pm ]
Post subject:  Re: Super Avenger Blacksteel Rubber OEM strap

D you are most likely right! I guess I did not read the post very well.


Hope life is good with you.

D

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/