I've ordered a cape cod
Sent from my LON-L29 using Tapatalk
| The Breitling Watch Source Forums https://www.breitlingsource.com/phpBB2/ |
|
| Scratch on Navitimer World lug https://www.breitlingsource.com/phpBB2/viewtopic.php?f=1&t=62386 |
Page 1 of 1 |
| Author: | bonerp [ Fri Mar 03, 2017 5:18 am ] |
| Post subject: | Scratch on Navitimer World lug |
Quick question I've managed to scratch the strap lug on my NW! Very slight but it needs remedying. Is the case/body safe to polish using methods I've seen on this site (dremel and various compounds) or will the case be damaged as a result? thanks |
|
| Author: | zak57 [ Fri Mar 03, 2017 5:34 am ] |
| Post subject: | Re: Scratch on Navitimer World lug |
If the scratch is not deep then a cape cod cloth (for a polished finish) or gentle use of a scotchbrite pad (for brushed) will do the job. A longer period of hand finishing is better than using mechanical means for a small job like that. Post a pic if you're unsure. Frankly, if its not noticeable then leave it alone, you can't avoid day to day wear and tear unless you never take it out of the box. |
|
| Author: | bonerp [ Fri Mar 03, 2017 6:17 am ] |
| Post subject: | Re: Scratch on Navitimer World lug |
I've ordered a cape cod Sent from my LON-L29 using Tapatalk |
|
| Author: | zak57 [ Fri Mar 03, 2017 6:42 am ] |
| Post subject: | Re: Scratch on Navitimer World lug |
A few minutes of earnest rubbing should deal with that....... |
|
| Author: | bonerp [ Fri Mar 03, 2017 6:45 am ] |
| Post subject: | Re: Scratch on Navitimer World lug |
thank you 
|
|
| Author: | themystro [ Fri Mar 03, 2017 4:33 pm ] |
| Post subject: | Re: Scratch on Navitimer World lug |
Yup, Cape Cod cloth will take care of that. |
|
| Author: | Danilamaster [ Sat Mar 04, 2017 10:16 am ] |
| Post subject: | Re: Scratch on Navitimer World lug |
Hello, the scratch is not that deep but you have any knowledge of using the power tools, a dremel with a hard buffing wheel with a gentle touch using a white polishing compound will take care of the problem. Lastly, for the final finish use the polinoxx with a loose buffing wheel to bring the surface to the final finish. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|