The Breitling Watch Source Forums

I can't figure out how to make the Zulu time match the local time. I can adjust the hours then adjust the rest by half hour increments. Right now it's about 7 minutes off and super annoying. Thanks for any help!




Sent from my iPhone using Tapatalk

From Aerospace manual:

2.6 SYNCHRONIZING THE ANALOG AND DIGITAL TIME DISPLAYS
after a battery replacement or, exceptionally, a manipulation error, it may
be necessary to synchronize the time shown by the hands with that displayed by the digital readout.
1. Select the neutral position.
2. Pull the crown out: the digitally displayed time is not the same as the time shown by the hands.
3. rotate the crown backward or forward until the hands show exaclty the same time as the display (rapid rotation of the crown will cause the hands to move in either direction by a complete hour).
4. Push the crown back in.

_________________
Transocean Unitime Worldtimer; B50 Night Mission Boutique Edition-Cobra Dial; SuperOcean Heritage Chronograph 44; Colt Chrono; Navitimer World; Super Avenger II; B-1; Chronomat No 94 (ltd); Emergency Super Quartz: 2009 Top Time; B13055 Windrider

Yea that was an obvious try. If I spin it the hand moves but the digital moves with it and keeps its error


Sent from my iPhone using Tapatalk

Finally figured it out. Turns out you have to set the digital clock first. Then the analog on a separate sequence. Such a pain!


Sent from my iPhone using Tapatalk