The Breitling Watch Source Forums

so I have a module 2.0 wolf single watch winder. never had a problem. rotate between a blackbird and a motors T. lately i've noticed several mornings in a row lately that the motors T drops out of the winder (luckily the door traps it in, but i dont like the thought of it continuing to wind with the crystal getting scratched against the glass door). has anyone had this problem? perhaps I should pack it in tighter with a cloth? interestingly enough, the blackbird is heavier than the motors T and it never comes out. must be the weight distribution.

Your not alone. My Wolf winder does the same thing with just my EVO in it. I guess they werent planning on Breitlings (heavy) being in thier winders. I solved my problem by cutting a "fake" credit card to fit beside the pilllow and now the pillow/watch is semi wedged in place. I havent hav a problem since.

It is a shame because these Wolf winders are awesomely quiet and have all the electronics needed. I have actually thought of getting a few more of these and gutting them for a DIY winder project, but I would have the cup at a greater angle.


Scott

_________________
Breitling Steelfish(black)
Breitling Steelfish(silver)
Panerai PAM 312
Bell & Ross BR03-92 Phantom
Steinhart BreitlingSource LE #5/15

i had the same problem with my SA so i used a old sock and wrapped around the pilllow

_________________
Super Avenger White, Steel & Diamond Bezel