i had the same problem with my SA so i used a old sock and wrapped around the pilllow
| The Breitling Watch Source Forums https://www.breitlingsource.com/phpBB2/ |
|
| Wolf Winder vs Motors T = falling out of winder https://www.breitlingsource.com/phpBB2/viewtopic.php?f=1&t=4567 |
Page 1 of 1 |
| Author: | siglo vi [ Tue Aug 26, 2008 7:12 am ] |
| Post subject: | Wolf Winder vs Motors T = falling out of winder |
so I have a module 2.0 wolf single watch winder. never had a problem. rotate between a blackbird and a motors T. lately i've noticed several mornings in a row lately that the motors T drops out of the winder (luckily the door traps it in, but i dont like the thought of it continuing to wind with the crystal getting scratched against the glass door). has anyone had this problem? perhaps I should pack it in tighter with a cloth? interestingly enough, the blackbird is heavier than the motors T and it never comes out. must be the weight distribution. |
|
| Author: | BroncoSport [ Tue Aug 26, 2008 7:39 am ] |
| Post subject: | |
Your not alone. My Wolf winder does the same thing with just my EVO in it. I guess they werent planning on Breitlings (heavy) being in thier winders. I solved my problem by cutting a "fake" credit card to fit beside the pilllow and now the pillow/watch is semi wedged in place. I havent hav a problem since. It is a shame because these Wolf winders are awesomely quiet and have all the electronics needed. I have actually thought of getting a few more of these and gutting them for a DIY winder project, but I would have the cup at a greater angle. Scott |
|
| Author: | subzero [ Tue Aug 26, 2008 7:52 am ] |
| Post subject: | |
i had the same problem with my SA so i used a old sock and wrapped around the pilllow
|
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|