| The Breitling Watch Source Forums https://www.breitlingsource.com/phpBB2/ |
|
| Bergeon Watch Band Tool? https://www.breitlingsource.com/phpBB2/viewtopic.php?f=1&t=17116 |
Page 1 of 1 |
| Author: | Mr Clean [ Wed Feb 24, 2010 5:45 pm ] |
| Post subject: | Bergeon Watch Band Tool? |
Anybody ever use one of these? http://www.esslinger.com/bergeonwatchbr ... older.aspx I searched for single screwdrivers in 1.8mm width (proper size?). but had a hard time finding just that size in a high quality single screwdriver. This band holding tool from Bergeon appears to have a 1.8mm screwdriver integrated into it. And it looks like it would keep the band and screwdriver properly aligned. Do we like it? Not like it? |
|
| Author: | Roffensian [ Wed Feb 24, 2010 5:52 pm ] |
| Post subject: | Re: Bergeon Watch Band Tool? |
That looks like overkill to me. I've tried using a Bergeon 160 (1.6mm) from my set and it works fine as the 180 seems unavailable singly now. If you buy a proper Bergeon (rather than a clone) and use it properly then you don't need anything to hold the bracelet while you loosen the screws, in fact I would rather not have anything holding it, I find it a lot easier to be able to maneuver things. Even when I am working on movements I tend to hold the movement rather than use a movement holder. |
|
| Author: | Sparwood [ Thu Feb 25, 2010 12:55 pm ] |
| Post subject: | Re: Bergeon Watch Band Tool? |
I also have the 1.60mm screw driver as I couldnlt find the 1.80mm available on its own either, works just fine. |
|
| Author: | Mr Clean [ Thu Feb 25, 2010 10:32 pm ] |
| Post subject: | Re: Bergeon Watch Band Tool? |
Sparwood wrote: I also have the 1.60mm screw driver as I couldnlt find the 1.80mm available on its own either, works just fine. Thanks Guys. I'll just keep it simple and go with the 1.6mm. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|