The Breitling Watch Source Forums

I need to remove a link from one side of my Bentley Speed Bracelet and then move it to the other side thus making the clasp "balanced" on my wrist. I removed the screw that holds the link but however nothing happens once the screw is removed? I didn't want to force anything so I've left it alone until I can get precise information.

Any one have any?

_________________
Breitling Bentley Motors
Breitling Chrono-Matic 49
Breitling Super Avenger
Breitling Cosmonaute 2010 limited edition
Rolex Submariner
Rolex GMT Master 11
Rolex Daytona
Rolex Sea Dweller Deepsea
Tag Heuer Carerra
Graham Chronofighter GMT Oversize

I've never dealt with a Speed bracelet but assuming that it's of similar construction to that of a Pilot or Pro bracelet you will need to remove both screws of a single link not just one. One end (side) of the link has two bars attached to it and the other end is free. One of the bars goes through the lower link and the other through the one above. Once you remove both screws then the outer piece should come off and the other side can be pulled out releasing the center link which will fall free.

This link may help.
http://www.breitlingsource.com/video_ar ... Adjustment

The Speed is identical in construction to all other Breitling bracelets and as br549 quite rightly said you need to remove both screws to remove a link.

_________________
Driver8

Site Moderator

EXCELLENT replies! I will try again this evening. Thank you both VERY much. This is most helpful.

_________________
Breitling Bentley Motors
Breitling Chrono-Matic 49
Breitling Super Avenger
Breitling Cosmonaute 2010 limited edition
Rolex Submariner
Rolex GMT Master 11
Rolex Daytona
Rolex Sea Dweller Deepsea
Tag Heuer Carerra
Graham Chronofighter GMT Oversize