The Breitling Watch Source Forums

Breitling Watch Information Forums, Navitimer, Chronomat
It is currently Thu Oct 31, 2024 3:12 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 9 posts ] 
Author Message
 Post subject: My watch loses time...
PostPosted: Wed Aug 29, 2007 7:59 am 
Offline
Breitling Newbie
Breitling Newbie

Joined: Wed Aug 29, 2007 7:55 am
Posts: 3
Likes: 0 post
Liked in: 0 post
Location: Hudson County NJ
Is it normal for my Breitling to lose time? I have had the watch for about 8 months. I recently had to set it becasue it was about 4 mins behind...
Please advise...
Thanks
Chris

_________________
Chris


Top
 Profile  
Reply with quote  
 Post subject:
PostPosted: Wed Aug 29, 2007 9:19 am 
Offline
Contributing Moderator
Contributing Moderator
User avatar

Joined: Fri Jul 27, 2007 5:09 am
Posts: 36521
Likes: 0 post
Liked in: 489 posts
Location: Ontario, Canada
Assuming that it is a relatively modern Breitling it is COSC certified as a chronometer. That means that it is accurate to within -4 to +6 seconds a day. Any gain or loss within that range would be considered normal.

If the watch is new (assuming it is automatic) it may take several weeks for it to settle and until then it may lose more than 4 seconds a day.

On the other hand (again assuming it is automatic) if the watch is several years old and has only just started losing time then it sounds like it is time for it to be serviced.


Top
 Profile  
Reply with quote  
 Post subject: Thanks
PostPosted: Wed Aug 29, 2007 10:31 am 
Offline
Breitling Newbie
Breitling Newbie

Joined: Wed Aug 29, 2007 7:55 am
Posts: 3
Likes: 0 post
Liked in: 0 post
Location: Hudson County NJ
I appreciate the feedback. It is a newer model, less than one year old. I will keep more careful attention to exactly how much it loses. When is it appropriate for a typical service?
Regards
Chris

_________________
Chris


Top
 Profile  
Reply with quote  
 Post subject:
PostPosted: Wed Aug 29, 2007 11:01 am 
Offline
Contributing Moderator
Contributing Moderator
User avatar

Joined: Fri Jul 27, 2007 5:09 am
Posts: 36521
Likes: 0 post
Liked in: 489 posts
Location: Ontario, Canada
Well not 8 months!

If you are using the watch for 'normal' wear you should be good for anything up to 5 or 6 years.

However, if you regularly rely on the waterproofing qualities of the watch - swimming, diving, etc, you will want to get it serviced every couple of years to ensure that the gaskets are still good.


Top
 Profile  
Reply with quote  
 Post subject:
PostPosted: Wed Aug 29, 2007 2:26 pm 
Offline
King of Ling
King of Ling
User avatar

Joined: Wed Aug 29, 2007 12:48 pm
Posts: 2092
Likes: 0 post
Liked in: 2 posts
Location: Fort Smith, AR USA
If you own a chronograph, and you are using the features of the watch, I have been told by a few jewelers it can rob it of a little accuracy. I've found this out with a Fortis Flieger I own. It seems I loose two minutes a week to my Rolex Submariner if I'm using my Fortis while flying cross country trips timing my checkpoints. If I don't use the chronograph features, the watch keeps better time.

Just my two cents.

~Brian


Top
 Profile  
Reply with quote  
 Post subject:
PostPosted: Thu Aug 30, 2007 7:06 am 
Offline
Breitling Fanatic
Breitling Fanatic

Joined: Tue Jul 03, 2007 12:50 pm
Posts: 219
Likes: 0 post
Liked in: 0 post
Location: Ontario, Canada
Using the chrono should only take away power reserve, accuracy should not be affected.

4 min behind - hard to tell, for sure it is loosing time, but how many sec per day are we talking about. The best way to do this is observe it for a month. Set your watch based on a reference (atomic clock), observe it for a month and see what the delta is.

From where you can calculate the the +/- is for the day. If it is well beyond the COSC specs, go back to your AD and have it regulated, providing they have all the tools including a water pres tester.

Pls bear in mind that COSC testing are done on movements only, no hands and they're not even in their respective cases. So when the watches are sent to the ADs, the movements may hit a bump during its travels and could cause some deviance.

Best,

Vernon


Top
 Profile  
Reply with quote  
 Post subject:
PostPosted: Fri Aug 31, 2007 3:07 am 
Offline
Breitling Connoisseur
Breitling Connoisseur
User avatar

Joined: Fri Jul 27, 2007 5:28 am
Posts: 960
Likes: 1 post
Liked in: 2 posts
I have to correct Vernon:

COSC testing is now done optically on the second hands of the movement.
That is why the UTC and the Copilot are the only nonchronometers.

Greatings
Thomas


Top
 Profile  
Reply with quote  
 Post subject:
PostPosted: Fri Aug 31, 2007 4:39 am 
Offline
Breitling Fanatic
Breitling Fanatic

Joined: Tue Jul 03, 2007 12:50 pm
Posts: 219
Likes: 0 post
Liked in: 0 post
Location: Ontario, Canada
Ah, that is something new. Thanks for the correction, much appreciated.

Alien wrote:
I have to correct Vernon:

COSC testing is now done optically on the second hands of the movement.
That is why the UTC and the Copilot are the only nonchronometers.

Greatings
Thomas


Top
 Profile  
Reply with quote  
PostPosted: Sat Aug 29, 2020 6:09 am 
Offline
Breitling Fanatic
Breitling Fanatic

Joined: Fri Aug 27, 2010 11:43 am
Posts: 158
Likes: 0 post
Liked in: 10 posts
Location: Montreal
4 mins in 8 months? That comes out to about 2 sec per day. That's extremely accurate for a mechanical watch.

_________________
Tudor BB
Breitling cosmonaute
Breitling aerospace chronometer
Oris aquis depth gauge
Oris Artelier Worldtimer Centennial
Omega Seamaster PO XL


Top
 Profile  
Reply with quote  

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 9 posts ] 

All times are UTC - 8 hours


Who is online

Users browsing this forum: No registered users and 16 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
 




Powered by phpBB® Forum Software © phpBB Group